Post #16 Error correction - back bracing.

After clamping down the center two back braces, I inspected the upper bout back brace (B-1) and discovered it was not perfectly parallel with the other braces.  I ended up removing it with hot water, a hair dryer and a spatula knife.  Below you can see the brace removed and the back cleaned up for re-gluing.  It was back to the bench belt sander to clean brace B-1 before installing.

This time I tripled check the square. 

And then installed the rest of the clamps.  After some glue squeeze out clean up, it was time to wait for it to dry and set up.